Electronics Engineering - Online Test
Q1. Circuit turn-off time of an SCR is defined as the time
Answer : Option C
Explaination / Solution:
No Explaination.
Q2. Solution of the variables x1 and x2 for the following equations is to be obtained by
employing the Newton-Raphson iterative method.
equation (i) 10x2 sinx1 - 0.8 = 0
equation (ii) 10x2 - 10x2 cosx1 - 0.6 = 0
Assuming the initial valued x1 = 0.0 and x2 = 1.0, the jacobian matrix is
Answer : Option B
Explaination / Solution:
Q3. A dual trace oscilloscope is set to operate in the Alternate mode. The control input of the multiplexer used in the y-circuit is fed with a signal having a frequency equal to
Answer : Option C
Explaination / Solution:
No Explaination.
Q4. The output Y of the logic circuit given below is
Answer : Option A
Explaination / Solution:
Q5. 
The bridge circuit shown in the figure below is used for the measurement of an
unknown element ZX. The bridge circuit is best suited when ZX is a
Answer : Option C
Explaination / Solution:
Q6. The r.m.s value of the current i(t) in the circuit shown below is
Answer : Option B
Explaination / Solution:
Q7. What is the minimum number of gates required to implement the Boolean function (AB + C) if we have to use only 2-input NOR gates?
Answer : Option B
Explaination / Solution:
No Explaination.
Q8. 
The CORRECT transfer characteristic is
Answer : Option D
Explaination / Solution:
It is a Schmitt trigger and phase shift is zero.
Q9. Given a vector field 
the line integral ∫ F.dl evaluated along
a segment on the x-axis from x=1 to x=2 is
the line integral ∫ F.dl evaluated along
a segment on the x-axis from x=1 to x=2 is
Answer : Option B
Explaination / Solution:
No Explaination.
Q10. If R(τ) is the auto correlation function of a real, wide-sense stationary random process, then which of the following is NOT true
Answer : Option C
Explaination / Solution:
No Explaination.
