Electrical Engineering - Online Test
Q1. The value of the line integral
along a path joining the origin (0, 0, 0) and the point (1, 1, 1) is
Answer : Option B
Explaination / Solution:
Q2. For the circuit shown below, taking the opamp as ideal, the output voltage Vout in terms of the input
voltages V1 , V2 and V3 is
Answer : Option D
Explaination / Solution:
Q3. The figure shows a two-generator system supplying a load of PD = 40 MW, connected at bus 2.
The fuel cost of generators G1 and G2 are : 
and the loss in the line is 
where the loss coefficient is specified in pu on a
100 MVA base. The most economic power generation schedule in MW is
and the loss in the line is where the loss coefficient is specified in pu on a
100 MVA base. The most economic power generation schedule in MW is
Answer : Option A
Explaination / Solution:
Q4. 
Answer : Option B
Explaination / Solution:
Q5. The locked rotor current in a 3-phase, star connected 15 kW, 4-pole, 230 V, 50 Hz induction motor at rated conditions is 50 A. Neglecting losses and magnetizing current, the approximate locked rotor line current drawn when the motor is connected to a 236 V, 57 Hz supply is
Answer : Option B
Explaination / Solution:
Q6. T he feedback system shown below oscillates at 2 rad/s when
Answer : Option A
Explaination / Solution:
Q7. The state variable description of an LTI system is given by
where y is the output and u is the input. The system is controllable for
Answer : Option D
Explaination / Solution:
Q8. In the 3-phase inverter circuit shown, the load is balanced and the gating scheme is 1800 -conduction mode. All the switching devices are ideal
If the dc bus voltage Vd = 300 V, the power consumed by 3-phase load is
Answer : Option D
Explaination / Solution:
Q9. The decimal value 0.5 in IEEE single precision floating point representation has
Answer : Option B
Explaination / Solution:
(0.5)10 = (1.0)2 × 2-1
So, exponent = -1 and fraction is 000 - - - 000
Q10. 
The clock frequency applied to the digital circuit shown in the figure below is 1kHz. If the initial state of the output of the flip-flop is 0, then the frequency of the output waveform Q in kHz is
Answer : Option B
Explaination / Solution:
No Explaination.
